CRANKSHAFT/PISTON/CYLINDER
12-12
Tighten the nuts in two or three steps alternately,
then tighten the nuts to the specified torque.
Remove the bearing caps and measure the com-
pressed plastigauge at its widest point on the
crankpin to determine the oil clearance.
If the oil clearance exceeds the service limit, select
the correct replacement bearings.
BEARING SELECTION
Numbers (1 or 2) on
the connecting rods
are the codes for
the connecting rod
I.D.
Record the connecting rod I.D. code number (1 or 2)
or measure the I.D. with the connecting rod bearing
cap installed without bearing inserts.
Letters (A or B) on
the crankweight are
the codes for the
crankpin O.D.s
from left to right.
If you are replacing the crankshaft, record the corre-
sponding crankpin O.D. code letter (A or B).
If you are reusing the crankshaft, measure the
crankpin O.D. with the micrometer.
TORQUE: 26 N·m(2.7kgf·m, 19 lbf·ft)
SERVICE LIMIT: 0.06 mm (0.002 in)
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
