FRONT WHEEL/SUSPENSION/STEERING
13-32
Install the fork cap into the fork tube.
INSTALLATION
Install the fork through the steering stem and top
bridge.
Align the top end of the fork tube with the upper
surface of the top bridge as shown.
Tighten the bottom bridge pinch bolt to the speci-
fied torque.
Tighten the fork cap to the specified torque if it was
removed.
Tighten the top bridge pinch bolt to the specified
torque.
Install the following:
– front fender (page 2-6)
– front brake caliper
– CBF600SA/NA (page 15-33)
– CBF600S/N (page 15-37)
– front wheel (page 13-20)
TORQUE: 39 N·m(4.0kgf·m, 29 lbf·ft)
BOTTOM BRIDGE PINCH BOLT
FORK TUBE
TORQUE: 22 N·m(2.2kgf·m, 16 lbf·ft)
TORQUE: 22 N·m(2.2kgf·m, 16 lbf·ft)
TOP BRIDGE PINCH BOLT
FORK CAP
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
