HYDRAULIC BRAKE
15-10
1. Squeeze the brake lever or push the brake pedal,
open the bleed valve 1/2 turn and then close the
valve.
2. Release the brake lever until the bleed valve has
been closed.
• Do not release the lever until the bleed valve has
been closed.
Repeat steps 1. and 2. until air bubbles do not
appear in the bleed hose.
After bleeding the air completely, tighten the bleed
valve to the specified torque.
Fill the reservoir with DOT 4 brake fluid from a
sealed container.
Connect a bleed hose to the right caliper upper
bleed valve.
1. Squeeze the brake lever, open the bleed valve 1/4
of a turn and then close it.
2. Release the brake lever slowly and wait several
seconds after it reaches the end of its travel.
• Do not release the lever until the bleed valve has
been closed.
Repeat steps 1. and 2. until air bubbles do not
appear in the bleed hose.
After bleeding the air completely, tighten the bleed
valve to the specified torque.
Fill the reservoir to upper level line (casting ledge)
with DOT 4 brake fluid.
TORQUE: 5.4 N·m (0.60 kgf·m, 4.0 lbf·ft)
TORQUE: 5.4 N·m (0.60 kgf·m, 4.0 lbf·ft)
UPPER LEVEL LINE (CASTING LEDGE)
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
