6 User Access
6.1 Getting started with the keypad
Honeywell 2024
133
security passcode to enter level 2 or level 3 mode. You can enter any value for the event log user ID.
If the unit is configured to log events in an event log, the user ID identifies the user who made the
changes in the event log.
For firmware version 1.0068 and later, of the 7 digits entered, the first two are the user id and the
last five are the passcode. By default only user 02 is permitted access to Level 2. The default
passcode is 20000, so the value entered would be 0220000. Other users can be granted access to
level 2 menus, but a user can only access level 2 if they are not granted access to level 3. (A single
user can access level 2, level 3, or neither, but cannot access both level 2 and level 3. Level 2
functionality is a subset of level 3 functionality.)
l
To enter passcode, press the UP arrow or the DOWN arrow at the current position to change the
displayed digit to the required numeral.
l
For example, press the UP arrow twice at the current position, the value 0000000 changes to
2000000.
l
Press the RIGHT arrow to move one position to the right. Using the UP arrow or the DOWN arrow
change the displayed digit to the required numeral.
l
For example, press the RIGHT arrow until you reach the sixth digit. At the sixth digit press the UP
arrow twice. The value 2000000 changes to 2000020.
l
Repeat this step until you enter the passcode of the instrument.
l
To accept changes after entering the last digit (all seven digits of passcode), press the RIGHT arrow.
Attention: You can also press OK for entering the passkey value.
The OK key enters the displayed digit at the current position and advances to the next position.
If the log in was successful, the display indicates that you are in level 2 mode. If the user ID or
passcode were invalid, you will be returned to the main level 1 menu.
l
Use the UP arrow and DOWN arrow to scroll through the main menu items (L2.2 through L2.7) in
level 2 mode.
l
Press OK to select the necessary main menu item.
l
Use the UP arrow and DOWN arrow to scroll through the submenu items in level 2 mode.
l
Press OK to select the necessary submenu.
l
Press ESC to return to the main menu item.
l
From the main menu item, press ESC to exit level 2 mode.
To Next Page
Loading...
Need help?
General
