To Next Page

To Previous Page

IFP-75/IFP-75HV Installation/Operation Manual — P/N LS10147-001SK-E:D 06/25/2021 5

Table of Contents

Section 1: Introduction ..................................................................................................................................................... 9

1.1: Overview of Basic System.................................................................................................................................................................................9

1.1.1: Hardware Features..................................................................................................................................................................................9

1.1.2: Network System Hardware Features ......................................................................................................................................................9

1.1.3: Software Features ...................................................................................................................................................................................9

1.2: About this Manual............................................................................................................................................................................................10

1.2.1: Terms Used in this Manual...................................................................................................................................................................10

1.3: Compatible Products........................................................................................................................................................................................10

Section 2: Agency Listings, Approvals, and Requirements........................................................................................ 12

2.1: Federal Communications Commission (FCC).................................................................................................................................................12

2.2: Underwriters Laboratories (UL)......................................................................................................................................................................13

2.2.1: Requirements for All Installations........................................................................................................................................................13

2.2.2: UL 864 9th and 10th Edition ................................................................................................................................................................13

2.2.3: Requirements for Central Station Fire Alarm Systems ........................................................................................................................13

2.2.4: Requirements for Local Protected Fire Alarm Systems .......................................................................................................................13

2.2.5: Requirements for Remote Station Protected Fire Alarm Systems........................................................................................................13

2.2.6: Requirements for the Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 720..................................14

2.2.7: NFPA Requirements.............................................................................................................................................................................14

Section 3: Prerequisites for Installation........................................................................................................................ 15

3.1: Inventory..........................................................................................................................................................................................................15

3.2: Environmental Specifications..........................................................................................................................................................................15

3.3: Software Downloads........................................................................................................................................................................................15

3.4: Electrical Specifications ..................................................................................................................................................................................15

3.5: Wiring Specifications.......................................................................................................................................................................................17

3.6: Board Assembly Diagram................................................................................................................................................................................18

3.7: Calculating Current Draw and Standby Battery ..............................................................................................................................................19

3.7.1: Current Draw Worksheet Requirements...............................................................................................................................................19

3.7.2: Current Draw Worksheet for IDP, SK SLC Devices ...........................................................................................................................19

3.7.3: Current Draw Worksheet for SD SLC Devices....................................................................................................................................22

Section 4: Control Panel Installation............................................................................................................................. 24

4.1: Mounting the Control Panel Cabinet...............................................................................................................................................................24

4.1.1: Preventing Water Damage....................................................................................................................................................................24

4.1.2: Removing the IFP-75 Assembly from the Housing .............................................................................................................................24

4.1.3: Dead Front Installation and Removal...................................................................................................................................................25

4.2: AC Connection.................................................................................................................................................................................................26

4.3: Battery Power ..................................................................................................................................................................................................27

4.3.1: Battery Accessory Cabinet ...................................................................................................................................................................28

4.4: SBUS Wiring ...................................................................................................................................................................................................29

4.4.1: Calculating Wiring distance for SBUS modules ..................................................................................................................................29

4.4.2: Wiring Configurations..........................................................................................................................................................................31

4.5: RA-100 Remote Annunciator Installation .......................................................................................................................................................32

4.5.1: Mounting the RA-100...........................................................................................................................................................................32

4.5.2: RA-100 Connection to the Panel..........................................................................................................................................................34

4.6: RA-1000 Remote Annunciator Installation .....................................................................................................................................................35

4.6.1: Mounting the RA-1000.........................................................................................................................................................................36

4.7: RA-2000 Remote Annunciator Installation .....................................................................................................................................................38

4.7.1: Mounting the RA-2000.........................................................................................................................................................................39

4.7.2: RA-2000 Connection to the Panel..........................................................................................

..............................................................41

4.8: 5824 Serial/Parallel Printer Interface Module Installation..............................................................................................................................41

4.8.1: Selecting 5824 Options.........................................................................................................................................................................41

4.9: 5880 LED Driver Module................................................................................................................................................................................42

4.9.1: 5880 Board Layout...............................................................................................................................................................................42

4.9.2: FACP Connection.................................................................................................................................................................................43

4.9.3: LED Wiring ..........................................................................................................................................................................................43

4.9.4: Dry Contact Wiring ..............................................................................................................................................................................44

4.10: 5865-3 / 5865-4 LED Annunciator Installation.............................................................................................................................................44

4.10.1: FACP Connection...............................................................................................................................................................................45

4.10.2: 5865 Mounting....................................................................................................................................................................................45

4.11: Configuring Modules.....................................................................................................................................................................................46