Honeywell HH490 - Check Digit; Interleaved 2 of 5 Message Length; NEC 2 of 5

HH490 User Guide 89
Check Digit
No Check Digit indicates that the scanner reads and transmits barcode data
with or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads
Interleaved 2 of 5 barcodes printed with a check digit, but will not transmit the
check digit with the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads
Interleaved 2 of 5 barcodes printed with a check digit, and will transmit this digit
at the end of the scanned data.
Default = No Check Digit.
* No Check Digit
Validate, but Don’t Transmit
Validate and Transmit
Interleaved 2 of 5 Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 82) for additional information. Minimum and
Maximum lengths = 2-80. Minimum Default = 6, Maximum Default = 80.
Minimum Message Length
Maximum Message Length
NEC 2 of 5
< Default All NEC 2 of 5 Settings >