HH490 User Guide 43
hex value for the character(s). If you are using barcodes to create your output
sequence, use the Programming Chart, beginning on page 211 to read the
alphanumeric combination that represents the ASCII characters. (99 is the
universal number, indicating all characters.)
5. End Output Sequence Editor
Use FF to terminate this string or to begin another output sequence. If you
are using barcodes, scan F F. Scan Save to save your entries.
Other Programming Selections
If you are creating an output sequence using barcodes, scan Discard (page 215)
to exit without saving any output sequence changes.
Output Sequence Editor Commands
SEQBLK
SEQPRE
SEQSUF
SEQSEP
SEQTTS1
SEQSAT
SEQTIM
SEQIPR
SEQISU
SEQISE
TRGSTO
FF
Sequence editor start command.
Add prefix to complete output sequences.
Add suffix to complete output sequences.
Add separators to complete output sequences.
Transmit partial sequence.
Define satisfactory subsets of full output sequence.
Timeout for sequence members when using SEQSAT.
Add prefix to partial output sequences.
Add suffix to partial output sequences.
Add separators to partial output sequences.
Timeout for partial output sequences.
Termination string.
Examples outlining how to use these commands are shown below.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
