50 HH490 User Guide
Require Output Sequence
When an output sequence is Required, all output data must conform to an edited
sequence or the scanner will not transmit the output data to the host device.
When it’s On/Not Required, the scanner will attempt to get the output data to
conform to an edited sequence but, if it cannot, the scanner transmits all output
data to the host device as is, or formatted according to the partial sequence
output format (see Partial Sequence on page 46).
When the output sequence is Off, the barcode data is output to the host as the
scanner decodes it.
Default = Off.
Note:
This selection is unavailable when the Multiple Symbols Selection is turned on.
Good Read Tone - Output Sequences
The scanner may be programmed to either beep or click in response to a good
read of each barcode in an output sequence, or to emit a beep or error tone for a
partial sequence.
Default = Good Read Click - Each Code in Sequence and Error
Tone - Partial Sequence Output.
Good Read Beep - Each
* Good Read Click - Each
Good Read Beep - Partial
* Error Tone - Partial Sequence
To Next Page
Loading...
