34 HH490 User Guide
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 211, then Save.
User-Specified Reread Delay
2D Reread Delay
Sometimes 2D barcodes can take longer to read than other barcodes. If you wish
to set a separate Reread Delay for 2D barcodes, scan one of the programming
codes that follows. 2D Reread Delay Off indicates that the time set for Reread
Delay is used for both 1D and 2D barcodes.
Default = 2D Reread Delay Off.
Character Activation
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the Character Activation Timeout (page 46) is reached, the
deactivation character is received (see Deactivation Character on page 46), or a
barcode is transmitted. Scan the On barcode to use character activation, then
use Activation Character (page 45) to select the character you will send from the
host to start scanning.
Default = Off.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
