Honeywell HH490 - Reread Delay

HH490 User Guide 33
Streaming Presentation
Mode - Enhanced
When using Preferred Symbology (page 50),
a lower priority symbol must be
centered on the aiming pattern to be read in Streaming Presentation Mode.
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free” modes. If
the scanner’s trigger is pulled when using a hands free mode, the scanner
changes to manual trigger mode. You can set the time the scanner should remain
in manual trigger mode by setting the Hands Free Time-Out. Once the time-out
value is reached, (if there have been no further trigger pulls) the scanner reverts
to the original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from
0- 300,000 milliseconds) from the Programming Chart, beginning on page 211,
then Save.
Default = 5,000 ms.
Hands Free Time-Out
Reread Delay
This sets the time period before the scanner can read the same barcode a second
time. Setting a reread delay protects against accidental rereads of the same
barcode. Longer delays are effective in minimizing accidental rereads. Use
shorter delays in applications where repetitive barcode scanning is required.
Reread Delay only works when in a Presentation Mode (see page 37).
Default =
Medium.
Short (500 ms)
* Medium (750 ms)
Long (1000 ms)
Extra Long (2000 ms)