106 HH490 User Guide
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda
is not found within this time period, the data can be either transmitted or
discarded, based on the setting you are using for UPC-E0 Addenda Required. Set
the length (in milliseconds) for this timeout by scanning the barcode below, then
setting the timeout (from 0-120 milliseconds) by scanning digits from the
Programming Chart, beginning on page 211 of this manual, then Save.
Default =
120.
Note:
The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-E0 Addenda Separator
When this feature is On, there is a space between the data from the barcode and
the data from the addenda. When turned Off, there is no space.
Default
=
On.
UPC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of
the scanned data or not.
Default
=
On.
To Next Page
Loading...
