Honeywell HH490 - Intercharacter Delay; User Specified Intercharacter Delay

HH490 User Guide 57
1
2
3
4
5
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay barcode below, then scan the number of 5ms delays from
the Programming Chart, beginning on page 211, then Save.
Intercharacter Delay
To remove this delay, scan the Intercharacter Delay barcode, then set the
number of delays to 0. Scan the Save barcode from the Programming Chart,
beginning on page 211.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays from the
Programming Chart, beginning on page 211, then Save.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for
a printable character to trigger the delay (see Lower ASCII Reference Table, page
205.
)
Delay Length
Character to Trigger Delay
To remove this delay, scan the Delay Length barcode, and set the number of
delays to 0. Scan the Save barcode from the Programming Chart, beginning on
page 211.
Intercharacter Delay
Prefix
Scanned Data
Suffix