36 HH490 User Guide
Character Activation Timeout
Character Deactivation
If you have sent a character from the host to trigger the scanner to begin
scanning, you can also send a deactivation character to stop scanning. Scan the
following On barcode to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to
terminate scanning.
Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart (Code Page 1252), page 207,
find the hex value that represents the character you want to use to terminate
scanning. Scan the following barcode, then use the Programming Chart,
beginning on page 211239 to read the alphanumeric combination that
represents that ASCII character. Scan Save to finish.
Default = 14 [DC4].
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights On
barcode, below. However, if you want to turn just the lights off, scan the Lights
Off barcode.
Default = Lights On.
Note:
This setting does not affect the aimer light. The aiming light can be set using Aimer
Mode (page 47).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
