Honeywell HH490 User Manual

HH490 User Guide 35
* Off
On
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), page 207, find the hex
value that represents the character you want to use to trigger scanning. Scan the
following barcode, then use the Programming Chart to read the alphanumeric
combination that represents that ASCII character. Scan Save to finish.
Default =
12 [DC2].
Activation Character
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the illumination
turns off and stops scanning after a good read. If you scan Do Not End
Character Activation After Good Read, the illumination remains on after a good
read.
Do Not End Character Activation
After Good Read
End Character Activation After
Good Read
Character Activation Timeout
You can set a timeout for the length of time the illumination remains on and
attempting to decode barcodes when using Character Activation Mode. Set the
length (in milliseconds) for a timeout by scanning the following barcode, then
setting the timeout (from 1-300,000 milliseconds) by scanning digits from the
Programming Chart, beginning on page 211239, then Save.
Default = 30,000 ms.

Honeywell HH490 Specifications

General

Duplex scanning	No
Maximum scan size	- mm
Optical scanning resolution	1280 x 800 DPI
Scanner type	Handheld scanner
Product color	White
Quantity per pack	1 pc(s)
Sensor type	-
Barcode reader	Yes
Daily duty cycle (max)	- pages
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Power supply type	DC
Optional connectivity	Serial (RS-232)

Weight and Dimensions

Depth	72.5 mm
Width	125 mm
Height	154 mm
Weight	130 g