90 HH490 User Guide
NEC 2 of 5 On/Off
Check Digit
No Check Digit indicates that the scanner reads and transmits barcode data
with or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit, the unit only reads NEC
2 of 5 barcodes printed with a check digit, but will not transmit the check digit
with the scanned data.
When Check Digit is set to Validate and Transmit, the scanner only reads NEC 2
of 5 barcodes printed with a check digit, and will transmit this digit at the end of
the scanned data.
Default
= No Check Digit
.
Validate, but Don’t Transmit
NEC 2 of 5 Message Length
Scan the barcodes below to change the message length. Refer to Message
Length Description (page 82) for additional information. Minimum and
Maximum lengths = 2-80. Minimum Default = 4, Maximum Default = 80.
To Next Page
Loading...
