HH490 User Guide 101
UPC-A On/Off
Note:
To convert UPC-A barcodes to EAN-13, see Convert UPC-A to EAN-13 on page
108.
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted
at the end of the scanned data or not.
Default
=
On
.
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the
beginning of the scanned data but can be programmed so it is not transmitted
(Off).
Default
=
On.
To Next Page
Loading...
