HH490 User Guide 23
CHAPTER 3 - INPUT/OUTPUT SETTINGS
Power Up Beeper
The scanner can be programmed to beep when it’s powered up. If you are using a
cordless system, the base can also be programmed to beep when it is powered
up. Scan the Off barcode(s) if you don’t want a power up beep.
Default = Power Up
Beeper On - Scanner.
Power Up Beeper Off - Scanner
* Power Up Beeper On -
Beep on BEL Character
You may wish to force the scanner to beep upon a command sent from the host.
If you scan the Beep on BEL On barcode below, the scanner will beep every time
a BEL character is received from the host.
Default = Beep on BEL Off.
To Next Page
Loading...
