HH490 User Guide 17
* Keyboard Conversion Off
Convert All Characters to
Convert All Characters to
Control Character Output
This selection sends a text string instead of a control character. For example,
when the control character for a carriage return is expected, the output would
display [CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart
(Code Page 1252) on page 207. Only codes 00 through 1F are converted (the first
column of the chart).
Default = Off.
Note:
Control + X (Control + ASCII) Mode overrides this mode.
Control Character Output On
* Control Character Output Off
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scanner sends key combinations for
ASCII control characters for values 00-1F. Windows is the preferred mode. All
keyboard country codes are supported. DOS mode is a legacy mode, and it does
not support all keyboard country codes. New users should use the Windows mode.
Refer to ASCII Conversion Chart (Code Page 1252), page 207 for CTRL+ X Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate prefix or suffix
information.
Support ALT 3 Digit HEX Mode: The scanner sends key combinations for ASCII
control characters for values 00-1F transmitted as the ALT key and 3 digits.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
