HH490 User Guide 145
CHAPTER 7 - IMAGING COMMANDS
The scanner is like a digital camera in the way it captures, manipulates, and
transfers images. The following commands allow you to alter the way the scanner
performs these functions.
Single-Use Basis
Imaging Commands with their modifiers send instructions to the scanner on a
single-use basis, and take effect for a single image capture. Once that capture is
complete, the scanner reverts to its imaging default settings. If you want to
permanently change a setting, you must use the serial default commands (see
Chapter 9). When the serial default command is used, that selection becomes the
new, permanent setting for the scanner.
Command Syntax
Multiple modifiers and commands can be issued within one sequence. If
additional modifiers are to be applied to the same command, just add the
modifiers to that command. For example, to add 2 modifiers to the Image Snap
command, such as setting the Imaging Style to 1P and the Wait for Trigger to 1T,
you would enter IMGSNP1P1T.
Note:
After processing an image capture command (IMGSNP), you must follow it with an
IMGSHP command if you want to see it on your terminal.
To add a command to a sequence, each new command is separated with a
semicolon. For example, to add the Image Ship command to the above sequence,
you would enter IMGSNP1P1T;IMGSHP.
The imaging commands are:
Image Snap - IMGSNP (page 145)
Image Ship - IMGSHP (page 149)
The modifiers for each of these commands follow the command description.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
