Honeywell HH490 - Addenda Timeout; EAN;JAN-8 Addenda Separator; Msi

HH490 User Guide 117
Required
* Not Required
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda
is not found within this time period, the data can be either transmitted or
discarded, based on the setting you are using for EAN/JAN-8 Addenda Required.
Set the length (in milliseconds) for this timeout by scanning the barcode below,
then setting the timeout (from 0-120 milliseconds) by scanning digits from the
Programming Chart, beginning on page 211 of this manual, then Save.
Default =
120.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
Addenda Timeout
EAN/JAN-8 Addenda Separator
When this feature is On, there is a space between the data from the barcode and
the data from the addenda. When turned Off, there is no space.
Default = On.
* On
Off
MSI
<Default All MSI Settings>