EasyManuals Logo

Honeywell HH490 User Manual

Honeywell HH490
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
HH490 User Guide 75
Compare characters
FE Compare the character in the current cursor position to the character “xx.” If
characters are equal, move the cursor forward one position.
Syntax = FExx
where
xx stands for the comparison character’s hex value for its ASCII code.
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 203
for decimal, hex and character codes.
Compare string
B2 Compare the string in the input message to the string “s.” If the strings are equal,
move the cursor forward past the end of the string. Syntax = B2nnnnS where
nnnn is the string length (up to 9999), and S consists of the ASCII hex value of
each character in the match string. For example, B2000454657374 will compare
the string at the current cursor position with the 4 character string “Test.”
Refer to the ASCII Conversion Chart (Code Page 1252), beginning on page 203
for decimal, hex and character codes.
Check for a number
EC Check to make sure there is an ASCII number at the current cursor position. The
format is aborted if the character is not numeric.
EC Example: Only output the data if the barcode begins with a number
If you want only data from barcodes that begin with a number, you can use EC to
check for the number.
Command string: ECF10D
EC is the “Check for a number” command
F1 is the “Send all characters” command
0D is the hex value for a CR
If this barcode is read,
the next data format, if there is one, will be
used on the data. If there is no other format, the format fails and the raw data is
output as AB1234.
If this barcode is read:
the data is output as:
1234AB
<CR>

Table of Contents

Other manuals for Honeywell HH490

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HH490 and is the answer not in the manual?

Honeywell HH490 Specifications

General IconGeneral
Duplex scanningNo
Maximum scan size- mm
Optical scanning resolution1280 x 800 DPI
Scanner typeHandheld scanner
Product colorWhite
Quantity per pack1 pc(s)
Sensor type-
Barcode readerYes
Daily duty cycle (max)- pages
Storage temperature (T-T)-40 - 60 °C
Operating temperature (T-T)0 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Power supply typeDC
Optional connectivitySerial (RS-232)
Weight and Dimensions IconWeight and Dimensions
Depth72.5 mm
Width125 mm
Height154 mm
Weight130 g

Related product manuals