Honeywell UDC3200 - Table 10-8 Computer Setpoint Associated Parameters

Modbus Read, Write and Override Parameters plus Exception Codes
When SP is overridden, the upper display becomes “C” momentarily, and the lower
display shows the CSP value as CSP XXXX.
Table 10-7.1 Shed Timer Reset
Parameter
Description
Register
Address
Data
Type
Access Data Range or
Enumerated Selection
Hex Decimal
Shed Timer
Reset
007F 127 FP W Exit Slave Mode
IR Only
Associated Parameters
Refer to Table 10-8 for the codes to display or change any of the parameters associated
with the computer setpoint.
Table 10-8 Computer Setpoint Associated Parameters
Parameter Register Address
Hex Decimal
Setpoint Limits 0007, 0008 007, 008
Local Setpoint #1 0027 039
Local Setpoint #2 0035 053
Local Setpoint #3 0074 116
Local Setpoint Selection 00AD 173
Computer Setpoint Ratio 005A 90
Computer Setpoint Bias 005B 91
Shed Timer Reset 007F 127
12/04 UDC3200 Universal Digital Controller Product Manual 191