Honeywell UDC3200 User Manual

Installation
2 Installation
2.1 Overview
Introduction
Installation of the UDC3200 consists of mounting and wiring the controller according to
the instructions given in this section. Read the pre-installation information, check the
model number interpretation (Subsection 2.3), and become familiar with your model
selections, then proceed with installation.
What’s in this section?
The following topics are covered in this section.
TOPIC See Page
2.1 Overview 11
2.2 Condensed Specifications 12
2.3 Model Number Interpretation 15
2.4 Control and Alarm Relay Contact Information 17
2.5 Mounting 18
2.6 Wiring 20
2.7 Wiring Diagrams
Composite Wiring Diagram
AC Line Voltage
Input 1 Connections
Input 2 Connections
Relay Output
Electromechanical
Solid State
Open Collector
Dual Electromechanical Relay
Current Output Connections
Three Position Step Control Connections w/o Dual Relay
Three Position Step Control Connections with Dual Relay
RS-422/485 Communications Option
Ethernet Communications Option
Auxiliary Output and Digital Inputs Option
Transmitter Power using Open Collector Output
Transmitter Power using Auxiliary Output
22
24
25
26
27
28
29
30
31
31
32
32
33
33
34
35
35
12/04 UDC3200 Universal Digital Controller Product Manual 11

Honeywell UDC3200 Specifications

General

Display	Dual 4-digit LED
Mounting	Panel Mount
Digital Inputs	2
Cutout	92 x 92 mm (3.62 x 3.62 in)
Input Types	Thermocouple, RTD, mA, mV, V
Output Types	Relay, Analog
Control Modes	On/Off, PID
Communication Protocols	RS-485, Modbus
Power Supply	100-240 VAC, 24 VDC
Alarm Relays	2
Dimensions	96 x 96 mm