Honeywell UDC3200 - Display Set up Group; Table 3-15 DISPLAY Group Function Prompts

Configuration
3.15 Display Set Up Group
Introduction
This group includes selections for Decimal place, Units of temperature, Language and
Power frequency.
Function Prompts
Table 3-15 DISPLAY Group Function Prompts
Function Prompt
Lower Display
Selections or
Range of Setting
Upper Display
Parameter
Definition
DECIMAL DECIMAL POINT LOCATION—This selection
determines where the decimal point appears in the
display.
NONE
ONE
TWO
THREE
NONE—No Decimal Place—fixed, no auto-ranging
ONE—One Place
TWO—Two Places
THREE—Three Places
ATTENTION Auto-ranging will occur for selections
of one, two or three decimal places. For example,
should the instrument be configured for two decimal
places and the PV exceeds 99.99, then the display
will change to a single decimal place so that values
of 100.0 and above can be shown.
TEMP UNIT TEMPERATURE UNITS—This selection will affect
the indication and operation.
DEG F
DEG F—Degrees Fahrenheit – Degrees F
Annunciator lighted
DEG C
DEG C—Degrees Centigrade – Degrees C
Annunciator lighted
NONE
NONE—No temperature annunciators lighted.
Upper and Lower Displays will show temperature in
Degrees Fahrenheit when inputs are configured for
Thermocouple or RTD types.
PWR FREQ
60 HZ
50 HZ
POWER LINE FREQUENCY—Select whether your
controller is operating at 50 or 60 Hertz.
ATTENTION For controllers powered by +24 Vdc,
this configuration should be set to the AC line
frequency used to produce the +24 Vdc supply.
Incorrect setting of this parameter may cause normal
mode noise problems in the input readings.
RATIO 2 INPUT 2 RATIO—This enables the Ratio for Input 2
to be set from the front panel. Input 2 must be
installed and enabled for this configuration to
operate.
DISABLE
DISABLE—Disables setting Ratio 2 from front panel.
92 UDC3200 Universal Digital Controller Product Manual 12/04