HP 5500 EI series - Page 164

153
Figure 40 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IS-IS:
# Configure Router A
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] isis enable 1
[RouterA-Ethernet1/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] isis enable 1
[RouterB-Ethernet1/1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] isis 1
[RouterC-isis-1] network-entity 10.0000.0000.0003.00
[RouterC-isis-1] quit
[RouterC] interface ethernet 1/3
[RouterC-Ethernet1/3] isis enable 1
[RouterC-Ethernet1/3] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] isis enable 1
[RouterC-Ethernet1/1] quit