HP 5500 EI series - Page 283

272
[RouterC-ospf-1-area-0.0.0.0] network 195.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
# Configure Router D.
<RouterD> system-view
[RouterD] ospf
[RouterD-ospf] area 0
[RouterD-ospf-1-area-0.0.0.0] network 194.1.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.0] network 195.1.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.0] quit
[RouterD-ospf-1] quit
3. Configure BGP connections:
# Configure Router A.
<RouterA> system-view
[RouterA] bgp 100
[RouterA-bgp] peer 192.1.1.2 as-number 200
[RouterA-bgp] peer 193.1.1.2 as-number 200
[RouterA-bgp] address-family ipv4 unicast
[RouterA-bgp-ipv4] peer 192.1.1.2 enable
[RouterA-bgp-ipv4] peer 193.1.1.2 enable
# Inject network 1.0.0.0/8 into the BGP routing table of Router A.
[RouterA-bgp-ipv4] network 1.0.0.0 8
[RouterA-bgp-ipv4] quit
[RouterA-bgp] quit
# Configure Router B.
[RouterB] bgp 200
[RouterB-bgp] peer 192.1.1.1 as-number 100
[RouterB-bgp] peer 194.1.1.1 as-number 200
[RouterB-bgp] address-family ipv4 unicast
[RouterB-bgp-ipv4] peer 192.1.1.1 enable
[RouterB-bgp-ipv4] peer 194.1.1.1 enable
[RouterB-bgp-ipv4] quit
[RouterB-bgp] quit
# Configure Router C.
[RouterC] bgp 200
[RouterC-bgp] peer 193.1.1.1 as-number 100
[RouterC-bgp] peer 195.1.1.1 as-number 200
[RouterC-bgp] address-family ipv4 unicast
[RouterC-bgp-ipv4] peer 193.1.1.1 enable
[RouterC-bgp-ipv4] peer 195.1.1.1 enable
[RouterC-bgp-ipv4] quit
[RouterC-bgp] quit
# Configure Router D.
[RouterD] bgp 200
[RouterD-bgp] peer 194.1.1.2 as-number 200
[RouterD-bgp] peer 195.1.1.2 as-number 200
[RouterD-bgp] address-family ipv4 unicast