280
[RouterB-bgp] address-family ipv6
[RouterB-bgp-ipv6] peer 9::2 enable
[RouterB-bgp-ipv6] quit
# Configure Router C.
<RouterC> system-view
[RouterC] bgp 65009
[RouterC-bgp] router-id 3.3.3.3
[RouterC-bgp] peer 9::1 as-number 65009
[RouterC-bgp] address-family ipv6
[RouterC-bgp-ipv6] peer 9::1 enable
3. Configure EBGP:
# Configure Router A.
<RouterA> system-view
[RouterA] bgp 65008
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] peer 10::1 as-number 65009
[RouterA-bgp] address-family ipv6
[RouterA-bgp-ipv6] peer 10::1 enable
# Configure Router B.
[RouterB-bgp] peer 10::2 as-number 65008
[RouterB-bgp] address-family ipv6
[RouterB-bgp-ipv6] peer 10::2 enable
4. Inject network routes to the BGP routing table:
# Configure Router A.
[RouterA-bgp-ipv6] network 10:: 64
[RouterA-bgp-ipv6] network 50:: 64
[RouterA-bgp-ipv6] quit
[RouterA-bgp] quit
# Configure Router B.
[RouterB-bgp-ipv6] network 10:: 64
[RouterB-bgp-ipv6] network 9:: 64
[RouterB-bgp-ipv6] quit
[RouterB-bgp] quit
# Configure Router C.
[RouterC-bgp-ipv6] network 9:: 64
[RouterC-bgp-ipv6] quit
[RouterC-bgp] quit
Verifying the configuration
# Display IPv6 BGP peer information on Router B.
[RouterB] display bgp peer ipv6
BGP local router ID: 2.2.2.2
Local AS number: 65009
Total number of peers: 2 Peers in established state: 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
To Next Page
Loading...
Need help?
General