To Next Page

To Previous Page

354

Figure 86 Network diagram

Configuration procedure

1. Configure IPv6 addresses for interfaces. (Details not shown.)

2. Configure basic OSPFv3:

# Configure Router A: enable OSPFv3 and specify the router ID as 1.1.1.1.

<RouterA> system-view

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] quit

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] ospfv3 1 area 1

[RouterA-Ethernet1/1] quit

[RouterA] interface ethernet 1/2

[RouterA-Ethernet1/2] ospfv3 1 area 1

[RouterA-Ethernet1/2] quit

# Configure Router B: enable OSPFv3 and specify the router ID as 2.2.2.2.

<RouterB> system-view

[RouterB] ospfv3 1

[RouterB-ospfv3-1] router-id 2.2.2.2

[RouterB-ospfv3-1] quit

[RouterB] interface ethernet 1/1

[RouterB-Ethernet1/1] ospfv3 1 area 0

[RouterB-Ethernet1/1] quit

[RouterB] interface ethernet 1/2

[RouterB-Ethernet1/2] ospfv3 1 area 1

[RouterB-Ethernet1/2] quit

# Configure Router C: enable OSPFv3 and specify the router ID as 3.3.3.3.

<RouterC> system-view

[RouterC] ospfv3 1

[RouterC-ospfv3-1] router-id 3.3.3.3

[RouterC-ospfv3-1] quit

[RouterC] interface ethernet 1/1

[RouterC-Ethernet1/1] ospfv3 1 area 0

[RouterC-Ethernet1/1] quit

[RouterC] interface ethernet 1/2

HP 5500 EI series User Manual

Other manuals for HP 5500 EI series