HP 5500 EI series - Page 392

381
[RouterB-Ethernet1/2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] isis 1
[RouterC-isis-1] network-entity 10.0000.0000.0003.00
[RouterC-isis-1] ipv6 enable
[RouterC-isis-1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] isis ipv6 enable 1
[RouterC-Ethernet1/1] quit
[RouterC] interface ethernet 1/2
[RouterC-Ethernet1/2] isis ipv6 enable 1
[RouterC-Ethernet1/2] quit
3. Configure BFD functions:
# Enable BFD and configure BFD parameters on Router A.
[RouterA] bfd session init-mode active
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] isis ipv6 bfd enable
[RouterA-Ethernet1/1] bfd min-transmit-interval 500
[RouterA-Ethernet1/1] bfd min-receive-interval 500
[RouterA-Ethernet1/1] bfd detect-multiplier 7
[RouterA-Ethernet1/1] return
# Enable BFD and configure BFD parameters on Router B.
[RouterB] bfd session init-mode active
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] isis ipv6 bfd enable
[RouterB-Ethernet1/1] bfd min-transmit-interval 500
[RouterB-Ethernet1/1] bfd min-receive-interval 500
[RouterB-Ethernet1/1] bfd detect-multiplier 6
Verifying the configuration
# Display BFD session information on Router A.
<RouterA> display bfd session
Total Session Num: 1 Up Session Num: 1 Init Mode: Active
IPv6 Session Working Under Ctrl Mode:
Local Discr: 1441 Remote Discr: 1450
Source IP: FE80::20F:FF:FE00:1202 (link-local address of Ethernet1/1 on Router
A)
Destination IP: FE80::20F:FF:FE00:1200 (link-local address of Ethernet1/1 on Router
B)
Session State: Up Interface: Eth1/1
Hold Time: 2319ms
# Display routes destined for 2001:4::0/64 on Router A.
<RouterA> display ipv6 routing-table 2001:4::0 64