HP 5500 EI series - Page 56

45
[RouterC-ospf-1] quit
3. Configure basic RIP:
# Configure Router C.
[RouterC] rip 1
[RouterC-rip-1] network 11.3.1.0
[RouterC-rip-1] version 2
[RouterC-rip-1] undo summary
# Configure Router D.
<RouterD> system-view
[RouterD] rip 1
[RouterD-rip-1] network 11.0.0.0
[RouterD-rip-1] version 2
[RouterD-rip-1] undo summary
[RouterD-rip-1] quit
# Configure RIP to redistribute routes from OSPF process 1 and direct routes on Router C.
[RouterC-rip-1] import-route direct
[RouterC-rip-1] import-route ospf 1
[RouterC-rip-1] quit
# Display the IP routing table on Router D.
[RouterD] display ip routing-table
Destinations : 15 Routes : 15
Destination/Mask Proto Pre Cost NextHop Interface
0.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0
10.1.1.0/24 RIP 100 1 11.3.1.1 Eth1/1
10.2.1.0/24 RIP 100 1 11.3.1.1 Eth1/1
10.5.1.0/24 RIP 100 1 11.3.1.1 Eth1/1
10.6.1.0/24 RIP 100 1 11.3.1.1 Eth1/1
11.3.1.0/24 Direct 0 0 11.3.1.2 Eth1/1
11.3.1.0/32 Direct 0 0 11.3.1.2 Eth1/1
11.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0
11.4.1.0/24 Direct 0 0 11.4.1.2 Eth1/2
11.4.1.0/32 Direct 0 0 11.4.1.2 Eth1/2
11.4.1.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
127.255.255.255/32 Direct 0 0 127.0.0.1 InLoop0
4. Configure route summarization:
# Configure route summarization on Router C to advertise only the summary route 10.0.0.0/8.
[RouterC] interface ethernet 1/2
[RouterC-Ethernet1/2] rip summary-address 10.0.0.0 8
# Display the IP routing table on Router D.
[RouterD] display ip routing-table
Destinations : 12 Routes : 12