To Next Page

To Previous Page

Web and MAC Authentication

Configuring the Switch To Access a RADIUS Server

Syntax: [no] radius-server

[host < ip-address >]

Adds a server to the RADIUS configuration or (with no)

deletes a server from the configuration. You can config-

ure up to three RADIUS server addresses. The switch uses

the first server it successfully accesses. (Refer to

“RADIUS Authentication and Accounting” on page 5-1.)

[key < global-key-string >]

Specifies the global encryption key the switch uses with

servers for which the switch does not have a server-

specific key assignment (below). This key is optional if

all RADIUS server addresses configured in the switch

include a server-specific encryption key. (Default: Null.)

Syntax: radius-server host < ip-address > key <server-specific key-string>

[no] radius-server host < ip-address > key

Optional. Specifies an encryption key for use during

authentication (or accounting) sessions with the speci-

fied server. This key must match the encryption key used

on the RADIUS server. Use this command only if the

specified server requires a different encryption key than

configured for the global encryption key, above.

The no form of the command removes the key configured

for a specific server.

For example, to configure the switch to access a RADIUS server at IP address

192.168.32.11 using a server specific shared secret key of ‘1A7rd’:

Figure 3-5. Example of Configuring a Switch To Access a RADIUS Server

3-17

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General