To Next Page

To Previous Page

Web and MAC Authentication

Configuring Web Authentication

Syntax:

[no] aaa port-access web-based <port-list>

Enables web-based authentication on the specified

ports. Use the no form of the command to disable web-

based authentication on the specified ports.

aaa port-access web-based <port-list> [auth-vid <vid>]]

no aaa port-access web-based <port-list> [auth-vid]

Specifies the VLAN to use for an authorized client. The

Radius server can override the value (accept-response

includes a vid). If auth-vid is 0, no VLAN changes occur

unless the RADIUS server supplies one.

Use the no form of the command to set the auth-vid to 0.

(Default: 0).

aaa port-access web-based [clear-statistics]

Clears (resets to 0) all counters used to monitor the

HTTP and Web-Auth control traffic generated in web

authentication session. (To display Web-Auth traffic

statistics, enter the show port-access web-based statis-

tics command.)

aaa port-access web-based <port-list > [client-limit <1-32>]

Specifies the maximum number of authenticated cli-

ents to allow on the port. (Default: 1)

Note: On switches where Web Auth and 802.1X can

operate concurrently, this limit includes the total num-

ber of clients authenticated through both methods.

3-22

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General