To Next Page

To Previous Page

Web and MAC Authentication

Configuring Web Authentication

ProCurve(config)# show port-access web-based

Port Access Web-Based Status

Auth Unauth Untagged Tagged Port % In RADIUS

Port Clients Clients VLAN VLANs COS Limit ACL

----- -------- -------- -------- ------ -------- ------ ------

1 1 1 4006 Yes 70000000 100 Yes

2 2 0 MACbased No Yes Yes Yes

3 4 0 1 Yes No No No

Figure 3-6. Example of show port-access web-based Command Output

Syntax: show port-access web-based clients [port-list]

Displays the session status, name, and address for each web-

authenticated client on the switch. The IP address displayed

is taken from the DHCP binding table (learned through the

DHCP Snooping feature).

If DHCP snooping is not enabled on the switch, n/a (not

available) is displayed for a client’s IP address.

If a web-authenticated client uses an IPv6 address, n/a - IPv6

is displayed.

If DHCP snooping is enabled but no MAC-to-IP address

binding for a client is found in the DHCP binding table, n/a

- no info is displayed.

ProCurve (config)# show port-access web-based clients

Port Access Web-Based Client Status

Port Client Name MAC Address IP Address Session Status

----- ------------ ------------- --------------- -------------

1 webuser1 0010b5-891a9e 192.192.192.192 Authenticated

1 webuser2 001560-b3ea48 n/a - no info Authenticating

1 webuser3 000000-111111 n/a - IPv6 Authenticating

3 webuser4 000000-111112 n/a Authenticating

Figure 3-7. Example of show port-access web-based clients Command Output

3-27

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General