To Next Page

To Previous Page

---- ----------- --------------------------------------- -------------

Web and MAC Authentication

Configuring MAC Authentication on the Switch

ProCurve(config)# show port-access mac-based

Port Access MAC-Based Status

Auth Unauth Untagged Tagged Port % In RADIUS

Port Clients Clients VLAN VLANs COS Limit ACL

---- ------- ------- -------- ------ -------- ------ ------

1 1 1 2003 Yes 70000000 100 Yes

2 2 0 MACbased No Yes Yes Yes

3 4 0 1 Yes No No No

Figure 3-12. Example of show port-access mac-based Command Output

Syntax: show port-access mac-based clients [port-list]

Displays the session status, name, and address for each

MAC-authenticated client on the switch. The IP address

displayed is taken from the DHCP binding table (learned

through the DHCP Snooping feature).

If DHCP snooping is not enabled on the switch, n/a (not

available) is displayed for a client’s IP address.

If a MAC-authenticated client uses an IPv6 address, n/a - IPv6

is displayed.

If DHCP snooping is enabled but no MAC-to-IP address

binding for a client is found in the DHCP binding table, n/a

- no info is displayed.

ProCurve(config)# show port-access mac-based clients

Port Access MAC-Based Client Status

Port MAC Address IP Address Session Status

1 001321-eb8063 2001:fecd:ba23:cd1f:dcb1:1010:9234:4088 unauthenticated

1 000000-11111 192.192.192.192 authenticated

2 00000-111111 n/a authenticating

Figure 3-13. Example of show port-access mac-based clients Command Output

3-37

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General