HP PROCURVE 2910AL User Manual

TACACS+ Authentication
Configuring TACACS+ on the Switch
numbers 0 through 15, with zero allowing only Operator privileges (and
requiring two logins) and 15 representing root privileges. The root privilege
level is the only level that will allow Manager level access on the switch.
Figure 4-4. Advanced TACACS+ Settings Section of the TACACS+ Server User Setup
Then scroll down to the section that begins with “Shell” (See Figure 4-5).
Check the Shell box.
Check the Privilege level box and set the privilege level to 15 to allow “root”
privileges. This allows you to use the single login option.
4-14

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)