HP PROCURVE 2910AL User Manual

11
12
Traffic/Security Filters and Monitors
Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-1
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-2
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-2
Filter Limits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-3
Using Port Trunks with Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-3
Filter Types and Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-3
Source-Port Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-4
Operating Rules for Source-Port Filters . . . . . . . . . . . . . . . . . . . . 11-4
Example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-5
Named Source-Port Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-6
Operating Rules for Named Source-Port Filters . . . . . . . . . . . . . 11-6
Defining and Configuring Named Source-Port Filters . . . . . . . . 11-7
Viewing a Named Source-Port Filter . . . . . . . . . . . . . . . . . . . . . . . 11-9
Using Named Source-Port Filters . . . . . . . . . . . . . . . . . . . . . . . . . 11-9
Static Multicast Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-15
Protocol Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-16
Configuring Traffic/Security Filters . . . . . . . . . . . . . . . . . . . . . . . . . . 11-17
Configuring a Source-Port Traffic Filter . . . . . . . . . . . . . . . . . . . . . . 11-18
Example of Creating a Source-Port Filter . . . . . . . . . . . . . . . . . . 11-19
Configuring a Filter on a Port Trunk . . . . . . . . . . . . . . . . . . . . . . 11-19
Editing a Source-Port Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-20
Configuring a Multicast or Protocol Traffic Filter . . . . . . . . . . . . . . 11-21
Filter Indexing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-22
Displaying Traffic/Security Filters . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-23
Configuring Port-Based and
User-Based Access Control (802.1X)
Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-1
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-3
Why Use Port-Based or User-Based Access Control? . . . . . . . . . . . . 12-3
General Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-3
User Authentication Methods . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-4
802.1X User-Based Access Control . . . . . . . . . . . . . . . . . . . . . . . . 12-4
xiv

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)