HP PROCURVE 2910AL User Manual

RADIUS Authentication and Accounting
Configuring the Switch for RADIUS Authentication
After two attempts failing due to
username or password entry
errors, the switch will terminate
the session.
Global RADIUS parameters
from figure 5-6.
These two servers will use the
global encryption key.
Server-specific encryption key
for the RADIUS server that will
not use the global encryption
key.
Note: The Webui access task
shown in this figure is available
only on the switches covered in
this guide.
Figure 5-7. Listings of Global RADIUS Parameters Configured In Figure 5-6
5-20

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)