To Next Page

To Previous Page

RADIUS Authentication and Accounting

Configuring RADIUS Accounting

■ Stop-Only:

• Send a stop record accounting notice at the end of the accounting

session. The notice includes the latest data the switch has collected

for the requested accounting type (Network, Exec, Commands, or

System).

• Do not wait for an acknowledgment.

The system option (page 5-40) always delivers stop-only operation because

the switch sends the accumulated data only when there is a reboot, reload,

or accounting on/off event.

Syntax: [no] aaa accounting < exec | network | system | commands > < start-stop

| stop-only > radius

Configures RADIUS accounting type and how data will be

sent to the RADIUS server.

For example, to configure RADIUS accounting on the switch with start-stop

for exec functions and stop-only for system functions:

Configures exec and system

accounting and controls.

Summarizes the switch’s

accounting configuration.

Exec and System accounting are

active. (Assumes the switch is

configured to access a reachable

Figure 5-12. Example of Configuring Accounting Types

5-41

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General