To Next Page

To Previous Page

Configuring Secure Shell (SSH)

Further Information on SSH Client Public-Key Authentication

Syntax: clear crypto public-key

Deletes the client-public-key file from the switch.

Syntax: clear crypto public-key 3

Deletes the entry with an index of 3 from the

client-public-key file on the switch.

Enabling Client Public-Key Authentication. After you TFTP a client-

public-key file into the switch (described above), you can configure the switch

to allow the following:

■ If an SSH client’s public key matches the switch’s client-public-key file,

allow that client access to the switch. If there is not a public-key match,

then deny access to that client.

Syntax: aaa authentication ssh login public-key none

Allows SSH client access only if the switch detects a match

between the client’s public key and an entry in the client-

public-key file most recently copied into the switch.

Caution To enable client public-key authentication to block SSH clients whose public

keys are not in the client-public-key file copied into the switch, you must

configure the Login Secondary as none. Otherwise, the switch allows such

clients to attempt access using the switch’s Operator password.

7-28

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General