EasyManuals Logo

HP PROCURVE 2910AL User Manual

HP PROCURVE 2910AL
594 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #342 background imageLoading...
Page #342 background image
IPv4 Access Control Lists (ACLs)
Configuring Extended ACLs
Action Command(s) Page
Enter or Remove a ProCurve(config)# ip access-list extended < name-str | 100-199 >
9-81
Remark ProCurve(config-ext-nacl)# [ remark < remark-str > | no < 1 - 2147483647 > remark ]
9-83
For numbered, extended ACLs only, the following remark commands can be
substituted for the above:
ProCurve(config)# access-list < 100 - 199 > remark < remark-str >
ProCurve(config)# [no] access-list < 100 - 199 > remark
Delete an Extended ProCurve(config)# no ip access-list extended < name-str | 100-199 > 9-74
ACL
For numbered, extended ACLs only, the following command can also be used:
ProCurve(config)# no access-list < 100 - 199 >
Standard ACLs use only source IPv4 addresses for filtering criteria, extended
ACLs use multiple filtering criteria. This enables you to more closely define
your IPv4 packet-filtering. Extended ACLs enable filtering on the following:
Source and destination IPv4 addresses (required), in one of the
following options:
specific host
subnet or group of addresses
any address
choice of any IPv4 protocol
optional packet-type criteria for IGMP, and ICMP traffic
optional source and/or destination TCP or UDP port, with a further
option for comparison operators and (for TCP) an option for estab-
lishing connections
filtering for TCP traffic based on whether the subject traffic is initi-
ating a connection (“established” option)
optional IP precedence and ToS criteria
The switch allows up to 512 ACLs, and determines the total from the number
of unique identifiers in the configuration. For example, configuring two ACLs
results in an ACL total of two, even if neither is assigned to an interface. If you
then assign a nonexistent ACL to an interface, the new ACL total is three,
because the switch now has three unique ACL names in its configuration. (For
more on ACL limits, refer to “Monitoring Shared Resources” on page 9-100.)
9-54

Table of Contents

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

HP PROCURVE 2910AL Specifications

General IconGeneral
ModelHP ProCurve 2910al
Switching Capacity128 Gbps
Throughput95.2 Mpps
ManagementWeb, CLI, SNMP
Jumbo Frame SupportYes
ManageableYes
Power100-240 VAC
Power SupplyInternal
Operating Temperature0°C to 45°C (32°F to 113°F)
StackingYes
MAC Address Table Size32000 entries
Routing ProtocolRIP, OSPF
FeaturesIPv6, VLAN, QoS, ACLs
Operating Humidity15% to 95% non-condensing
Uplink Ports4
Power over EthernetYes (PoE+ models available)

Related product manuals