IPv4 Access Control Lists (ACLs)
Configuring Extended ACLs
For other IPv4 ACL topics, refer to the following:
Topic Page
configuring named, standard ACLs 9-46
configuring numbered, standard ACLs 9-49
configuring named, extended ACLs 9-55
applying or removing an ACL on an interface 9-73
deleting an ACL 9-74
editing an ACL 9-75
sequence numbering in ACLs 9-76
including remarks in an ACL 9-81
displaying ACL configuration data 9-85
creating or editing ACLs offline 9-94
enabling ACL “Deny” logging 9-96
Creating or Adding to an Extended, Numbered ACL. This command is
an alternative to using ip access-list extended < name-str > and does not use the
Named ACL (nacl) context. (For an extended ACL syntax summary, refer to
table 9-7 on page 9-53.)
Syntax: access-list < 100-199 > < deny | permit > < ip | ip-protocol | ip-protocol-nbr >
< any | host < SA > | SA/mask-length | SA < mask >>
< any | host < DA > | DA/mask-length | DA < mask >>
[ precedence < 0 - 7 | precedence-name >]
[ tos < tos-bit-setting >
[ log ]
9-66
To Next Page
Loading...
