Security Overview
Getting Started with Access Security
The Welcome window appears.
Figure 1-2. Management Interface Wizard: Welcome Window
This page allows you to choose between two setup types:
• Typical—provides a multiple page, step-by-step method to configure
security settings, with on-screen instructions for each option.
• Advanced—provides a single summary screen in which to configure
all security settings at once.
3. To enter the wizard, choose a setup option and then click Continue.
• Typical (multi-page setup): when you select this option, you will get
an alert indicating that configuration changes will be lost if you click
on the Web browser’s navigation tabs. Click OK to close the alert and
then advance through the following setup pages: Operator Password,
Manager Password, SNMP, Telnet, SSH, Web Management GUI, USB
Autorun, Timeout (see pages for details and setup options).
At each page, you have the following options:
– Enter a new value and/or make a new selection, or click Continue
to keep the current value and proceed to the next page setup.
When you have gone through all configurable options, the sum-
mary setup page appears (see step 4).
– To quit the Setup and return to the Welcome window without
saving any changes, click Exit at any time.
– To return to the previous screen(s), click Back at any time.
• Advanced (single page setup): when you select this option, the sum-
mary setup page appears immediately (see step 4).
1-14
To Next Page
Loading...
Need help?
General
