11-11
Traffic/Security Filters and Monitors
Filter Types and Operation
Figure 11-7. Example of the show filter Command
Using the IDX value in the show filter command, we can see how traffic is
filtered on a specific port (Value).The two outputs below show a non-
accounting and an accounting switch port.
ProCurve(config)# show filter
Traffic/Security Filters
An automatically assigned index
number used to identify the filter for
a detailed information listing. A filter
retains its assigned IDX number for
as long as the filter exists in the
switch. The switch assigns the
lowest available IDX number to a new
filter. This can result in a newer filter
having a lower IDX number than an
older filter if a previous (source-port
or named source-port) filter deletion
created a gap in the filter listing.
IDX Filter Type | Value
--- ------------ + -------------------
1 Source Port | 2
2 Source Port | 3
3 Source Port | 4
4 Source Port | 5
5 Source Port | 6
6 Source Port | 8
7 Source Port | 9
8 Source Port | 12
20 Source Port | 24
21 Source Port | 25
22 Source Port | 26
23 Source Port | 7
24 Source Port | 10
25 Source Port | 11
26 Source Port | 1
Indicates the port number or port-
trunk name of the source port or trunk
assigned to the filter.
To Next Page
Loading...
