HP PROCURVE 2910AL User Manual

multiple ACL application types in use … 6-15
NAS-Prompt-User service-type value … 5-14
network accounting … 5-35
operating rules, switch … 5-6, 6-7, 6-8, 6-7, 6-8
rate-limiting … 6-4, 6-6, 6-4
security … 5-13, 5-4, 5-37, 5-47, 5-19, 5-8, 5-14,
2-12, 2-16, 5-46, 5-45
SNMP access security not supported … 5-4
statistics, viewing … 5-43
terminology…5-5
TLS … 5-6
vendor specific attributes … 5-34, 5-28, 6-4
VSAs … 5-29
web browser security not supported … 5-7, 5-25,
5-4, 5-25
RADIUS-assigned ACLs … 6-9, 9-6
802.1X port-based access … 6-17
ACE, defined … 6-9
application type … 6-10
contrasting dynamic and static … 6-13
DA, defined … 6-10
defined … 6-9, 6-16, 6-10, 6-17
filters … 6-13
implicit deny, defined … 6-10
See wildcard.
mask … 6-10, 6-15, 6-17
outbound traffic, defined … 6-10
permit, defined … 6-11
resource monitor … 6-30
See also ACLs.
source routing, caution … 6-14, 6-18, 6-11, 6-16
terminology…6-9
vendor-specific attribute … 6-18
wildcard … 6-10, 6-11
rate-limit
override … 12-62
rate-limiting … 10-24
RADIUS administered … 5-4, 6-7, 6-6, 6-4, 6-5
remote-id
changing … 10-10
snooping … 10-9
reserved port numbers … 7-18, 8-20
Reset-on-clear
disabled when saving security credentials to
configuration file … 2-20
resource monitor
See Management and Configuration Guide.
RFCs
RFC 2548 … 5-34
routing
source-routing, caution … 6-14, 9-19, 9-34
RSA key, cert …7-10
S
SA …9-12
security
authorized IP managers … 14-1
per port … 13-3
security credentials
802.1X credentials saved to configuration
file … 2-15, 2-21
copying configurations on the switch … 2-20,
2-19
disabling Reset-on-clear option … 2-20, 2-19,
2-10
enabling storage in configuration file … 2-11
manager username and password … 2-12
operator username and password … 2-12
RADIUS … 2-16
saving to running configuration with include-
credentials … 2-19
SNMPv3 … 2-14, 2-16, 2-21
TACACS … 2-15
viewing in running configuration … 2-11, 2-19
when SNMPv3 credentials in downloaded file
are not supported … 2-21
security violations
detecting … 10-23
notices of … 13-33
security, ACL
See ACL, security use.
security, password
See SSH.
setting a password …2-6
shared secret key
RADIUS … 2-12, 2-16
TACACS … 2-12, 2-15
single sign-on …4-11
SNMP
authentication failures … 10-23
disabling access to authentication MIB … 1-16
password and username configuration … 2-3
RADIUS access to auth config MIB … 5-4
trap generation … 10-25
SNMPv3
8 – Index

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)