HP ProCurve 5400zl

access-method
■ [no] ip authorized-managers IP-ADDR access-method < all | ssh | telnet | ... >
Dene an access method desired.
Supported Values:
■ all
■ ssh
■ telnet
■ web
■ snmp
■ tftp
address
■ [no] ip address
Usage: [no] ip address [dhcp-bootp|IP-ADDR/MASK-LENGTH]
Description: Set IP parameters for communication within an IP network.
Parameters:
o dhcp-bootp - The switch attempts to get its conguration from a
DHCP/Bootp server.
o IP-ADDR/MASK-LENGTH - Assign an IP address to the switch.
The IP-ADDR/MASK-LENGTH may be specied in two ways using the
following syntax:
ip address 192.32.36.87/24
ip address 192.32.36.87 255.255.255.0
Both of the statements above would have the same effect.
Next Available Options:
■ ip-addr -- Interface IP address/mask. (IP-ADDR/MASK-LENGTH) (p. 302)
■ dhcp-bootp -- Configure the interface to use DHCP/Bootp server to acquire parameters.(p. 297)
addrmask
■ [no] ip icmp addrmask
Usage: [no] ip icmp addrmask
Description: Enable/disable address mask replies.
arp-age
■ [no] ip arp-age
Usage: [no] ip arp-age <[0..1440]|innite>
Description: Modify Address Resolution Protocol (ARP) table entry timeout,
specied in minutes. You can set the age up to 1440 minutes (24 hours).
The default timeout is 20 minutes.
o <0..1440> - timeout specied in minutes.
294© 2009 Hewlett-Packard Development Company, L.P.
ipCommand Line Interface Reference Guide