Next Available Options:
■ source-ip-vlan -- Specify the VLAN to use as a source for Candidate-BSR router IP address
(PIM-SM must be enabled on this VLAN). (VLAN-ID) (p. 488)
■ hash-mask-length < 1 to 32 > -- Specify the length (in bits) of the hash mask. (p. 480)
■ priority < 0 to 255 > -- Specify the priority for the Candidate Bootstrap router. (p. 484)
■ bsm-interval < 5 to 300 > -- Specify the interval for sending Bootstrap messages on PIM-SM
interfaces. (p. 477)
chain-name
■ router ospf area OSPF-AREA-ID virtual-link IP-ADDR md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
■ router ospf area backbone virtual-link IP-ADDR md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
cost
■ router ospf area OSPF-AREA-ID stub < 0 to 16777215 >
Enter cost to use when injecting default routes
into the area.
Range: < 0 to 16777215 >
■ router ospf area backbone stub < 0 to 16777215 >
Enter cost to use when injecting default routes
into the area.
Range: < 0 to 16777215 >
dead-interval
■ router ospf area OSPF-AREA-ID virtual-link IP-ADDR dead-interval < 1 to 65535 >
Set dead interval in seconds; the default is 40.
Range: < 1 to 65535 >
■ router ospf area backbone virtual-link IP-ADDR dead-interval < 1 to 65535 >
Set dead interval in seconds; the default is 40.
Range: < 1 to 65535 >
default-metric
■ router ospf default-metric < 0 to 16777215 >
Usage: default-metric <0-16777215>
Description: The default metric used for advertising external routes imported
into OSPF by this router.
Range: < 0 to 16777215 >
■ router rip default-metric < 1 to 15 >
Usage: default-metric <1-15>
478© 2009 Hewlett-Packard Development Company, L.P.
routerCommand Line Interface Reference Guide
To Next Page
Loading...
