EasyManuals Logo

HP ProCurve 5400zl User Manual

HP ProCurve 5400zl
765 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #479 background imageLoading...
Page #479 background image
Description: Enable/disable advertisement of summarized routes.
Summarization mechanisms should be disabled when using both
version 1 and version 2 of RIP within a single network.
backbone
â–  router ospf area backbone
The backbone area (the same as 0.0.0.0).
Next Available Options:
â–  normal -- Define a "normal" area.(p. 482)
â–  nssa < 0 to 16777215 > -- Define a "not-so-stubby" area (or NSSA) and its cost.(p. 483)
â–  stub -- Define a "stub" area and specify its cost.(p. 489)
â–  range -- Summarize routes matching address/MASK pair.(p. 484)
â–  virtual-link -- Specify a virtual neighbor. (IP-ADDR) (p. 492)
bsm-interval
â–  router pim bsr-candidate bsm-interval < 5 to 300 >
Specify the interval for sending Bootstrap messages on PIM-SM interfaces.
Range: < 5 to 300 >
bsr-candidate
â–  [no] router pim bsr-candidate
Usage: bsr-candidate [source-ip-vlan <VLAN-ID>]
[hash-mask-length <1-32>]
[priority <0-255>]
[bsm-interval <5-300>]
no bsr-candidate [source-ip-vlan <VLAN-ID>]
Description: Congure the router to advertise itself as the Candidate
Bootstrap Router (Candidate-BSR) for a PIM-SM domain. When
enabling router to be a Candidate-BSR the VLAN ID must be
specied, which IP address will be advertised as a
Candidate-BSR address. PIM-SM must be enabled on the VLAN.
Use 'no' form of this command to disable the router to be a
Candidate-BSR.
NOTE: It is recommended that the same routing switch is
congured as both the Candidate-BSR and the Candidate-RP.
Parameters:
o source-ip-vlan <VLAN-ID> - The VLAN which IP address will be advertised
as the Candidate-BSR IP address.
o hash-mask-length <1-32> - The mask length (in bits) used by the
PIM-SM hash function when selecting an RP. The default is 30.
o priority <0-255> - The priority for the Candidate-BSR for the
local PIM-SM domain. The larger value means the higher priority.
The default is 0.
o bsm-interval <5-300> - The interval (in seconds) for sending periodic
Bootstrap messages on all PIM-SM interfaces, when this router is
the elected BSR. The default is 60 seconds.
477© 2009 Hewlett-Packard Development Company, L.P.
routerCommand Line Interface Reference Guide

Table of Contents

Other manuals for HP ProCurve 5400zl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5400zl and is the answer not in the manual?

HP ProCurve 5400zl Specifications

General IconGeneral
BrandHP
ModelProCurve 5400zl
CategorySwitch
LanguageEnglish

Related product manuals