HP ProCurve 5400zl

'spanning-tree legacy-mode' is the equivalent of executing:
spanning-tree legacy-path-cost
spanning-tree force-version stp-compatible
'no spanning-tree legacy-mode' is the equivalent of executing:
no spanning-tree legacy-path-cost
spanning-tree force-version mstp-operation
legacy-path-cost
■ [no] spanning-tree legacy-path-cost
Set 802.1D (legacy) or 802.1t (not legacy) default pathcost values.
max-hops
■ spanning-tree max-hops < 1 to 40 >
Set the max number of hops in a region before the MST BPDU is discarded and the
information held for a port is aged (default is 20).
Range: < 1 to 40 >
maximum-age
■ spanning-tree maximum-age < 6 to 40 >
Set maximum age of received STP information before it is discarded.
Range: < 6 to 40 >
mcheck
■ spanning-tree [ETHERNET] PORT-LIST mcheck
Force the port to transmit RST BPDUs.
mode
■ spanning-tree [ETHERNET] PORT-LIST mode < Norm | Fast | Uplink >
Set spanning tree operation mode.
Supported Values:
■ Norm -- Normal spanning tree mode.
■ Fast -- Fast spanning tree mode.
■ Uplink -- Fast Uplink spanning tree mode.
MSTID
■ [no] spanning-tree instance < 1 to 16 >
ID of the MST instance to congure.
Range: < 1 to 16 >
Next Available Options:
■ vlan -- Configure VLANs for the MST instance.(p. 653)
■ priority < 0 to 15 > -- Set the device priority for the MST instance (the value is in range of
0-61440 divided into steps of 4096 that are numbered from 0 to 15, default is step 8).(p. 652)
■ port-list -- Configure MST instance ports parameters ([ethernet] PORT-LIST) (p. 648)
645© 2009 Hewlett-Packard Development Company, L.P.
spanning-treeCommand Line Interface Reference Guide