Installing Hardware Options
Replacing a Hot-Plug Fan
To replace a hot-plug fan:
1. Align the fan with the fan bay.
2. Slide the fan down into its bay.
3. Press down on the top of the fan until the lock engages.
Figure 5-36: Installing a hot-plug fan
4. Be sure that the LED on the fan and the internal health LED on the front panel
LED assembly are illuminated green, indicating that the system is functioning
properly. For detailed information on LEDs, refer to Appendix E, “System LEDs
and Switches.”
5. If any of the LEDs indicates an error, refer to Appendix H, “Troubleshooting,” or
refer to the HP Servers Troubleshooting Guide on the Documentation CD for
instructions.
6. Close the rear access panel.
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide 5-43
HP CONFIDENTIAL
Writer: Karen Hale File Name: f-ch5 Installing Hardware Options.doc
Codename: Dwarf Part Number: 230835-003 Last Saved On: 6/26/03 9:31 AM
To Next Page
Loading...
