HP Proliant DL580 - Internal PCI-X Hot Plug Leds and Button

System LEDs and Switches
Figure E-6: Internal PCI-X Hot Plug LEDs and button
Table E-7: Internal PCI-X Hot Plug LEDs and Button
Item Description Status
1 Slot fault LED (amber) On = Slot requires attention. There may be a
problem with the slot, the PCI-X board, or the
driver. Check the green LED before opening the
slot.
Off = Slot does not require attention.
2 Slot power LED (green)
On = Power is applied to the slot. Do not open.
Blinking = Power to slot is being turned off or on.
This process may take several minutes. Do not
open the slot release lever until the green LED is
completely off. Do not open.
Off = You may replace or remove a board in this
slot only.
3 PCI-X Hot Plug button (port)
Note: If the any of the LEDs indicates an error, refer to Chapter 7, “PCI-X Technology” or
Appendix H, “Troubleshooting,” for more information.
E-8 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Karen Hale File Name: p-appe System LEDs and Switches3.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:49 AM